I was not happy with many of the adxl mounts that I could find. I liked that the original model used a press fit to attach the mount temporarily. Unfortunately I did not have the Fystec input shaper.

The original part was only available as a .stl and my Fusion 360 skills are beginner at best. I didn't know how to reverse engineer that into a workable Fusion part so I took my calipers and copied the part from measurements. This is Version 3. I tried to model some cool surfaces like the miniSB.

I printed this part with standard Voron PIF settings. I used Hatchbox ABS at 235/100.

When installing, I would recommend using a nylon or other type washer between the screw heads and the adxl board to be on the safe side. Use M3 screws threaded directly into the part but do not try to tighten them down too much or it will strip out.