US General Mini box double stack adapter filler

This is my remix of peach1993 US General Mini box double stack adapter, https://makerworld.com/en/models/1998289-us-general-mini-box-double-stack-adapter#profileId-2151256 

The purpose of the remix is there wasn't enough clearance for the brackets on side cabinets and accessories if you want to add to your mini toolbox a bit. I removed the peg that goes in the bottom of the top toolbox and made the adapters taller to be the same height of the side locker cabinet I added from chuck zrk here, https://makerworld.com/en/models/2085486-us-general-mini-tool-box-hutch-with-lockers#profileId-2253951 

(I modified the Mini Tool Box Side Cabinet on the left from Fish Adventurer here, https://makerworld.com/en/models/1120209-mini-tool-box-side-cabinet#profileId-2427954 (I DO NOT OWN THE RIGHTS TO THE MINI TOOL BOX SIDE CABINET SO I WILL NOT BE POSTING THE REMIX I CREATED DUE TO LICENSING PERMISSIONS, PLEASE DO NOT ASK. IF THE MAKERS PERMISSIONS CHANGE I WILL UPLOAD AT THAT TIME)).

The longer adapter is used as a filler so the gap in between the toolboxes is filled in. I did not make all 3 pieces attached together due to possible variations in sizing. 

This may or may not work for similar mini toolboxes like Kobalt, Performax, Duralast, I do not have access to them to test fit. I would recommend printing just one piece as a test. If someone able to test, and can post pictures, that would be great! 

I used 6x3mm Neodymium Magnets and press fit them, I think it was 7 or 8 per hole, to hold the brackets in place. Do to variations in sizes of magnets they maybe be very tight. Magnets I used from the same manufacture even had slight sizing differences. You may or may not need to reem the whole a little for the magnets to fit. I did not reem any but some were extremely tight to press in. These are the ones I used: https://www.amazon.com/dp/B0FP1VX95X?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2 

Printed on Bambu X1C in PETG HF Lime Green