Here is a modern version of my self-watering pot for plants. It is equipped with a gauge to check the water level at a glance. It can actually support 8 20mm baskets. I'll add more sizes in the following days. I also add a little funnel in the middle to make infill more easy.

This pot is designed on the hydroponic principle, so care must be taken to maintain the same level of water.

Instructions :

Print the tanker with an 20 % infill, 15 minimum

Holder, baskets and gauge can be printed with a 10% infill, ideally 15 for the gauge.

I print it at 150mm/s because my printer can do it but 90 or 60 mm/s do the job

It works with PLA but PETG for the tank ensures long-lasting watertightness

Feel free to leave a comment to ask questions, make suggestions or other.
Don't forget to post your make !