Bruce Lee hueforge
Copyright Claim
Bruce Lee hueforge
Boost
9
25
5
Print Profile(1)
0.08mm layer, 1 walls, 100% infill
Designer
2.9 h
1 plate
Open in Bambu Studio
Boost
9
25
5
0
14
10
Released
Description
Bruce hueforge
*created with filament painting technique using hueforge software.
Remember if you want to scale, do it only with x and y axis, z must be the same as original.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Basic Yellow
PLA BambuLab Basic Jade White
Swap Instructions: if you don't have ams just put pause on specified layers and swap filamen manually
Start with Black
At layer #8 (0.72mm) swap to Yellow
At layer #17 (1.44mm) swap to Jade White for the rest.
Comment & Rating (5)
All
Print Profile
0.08mm layer, 1 walls, 100% infill
great
0
Reply
Turned out good. I scalled it to fit an 8" shadowbox frame and it looks good. My expectations were higher because I was expecting the cover photo but now I realize that it was the starting photo to make the hueforge. That was my first venture in trying something like this, thank you.
The designer has replied
0
Reply
thanks for honest opinion. tried to make it as close as i could ;)
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
nice
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld