3D Hibiscus flower
Copyright Claim
3D Hibiscus flower
Boost
37
53
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill scale 50%
40 min
2 plates
Boost
37
53
6
0
57
20
Released
Description
Print the petals and shape them accordingly. I used my oven as a heat source here because I didn't have a heat gun at the time.
Note that the petals on the middle of the print supposed to fuse a little bit together, I found this as the best solution for the print to be more stable and not to wobble at the top of the print. I cut them apart easily with a scalpel and then started the deforming.
I used a 25 line wide brim to print the flower, adds additional stability.
Super glue the parts together as you see on the video.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill scale 50%
good also the creator is good at giving feedback👍
(Edited)The designer has replied
1
Reply
Hello, the model doesn't resemble the one in the photo probably because, as stated in the description, it's scaled down by 50%. My test prints with the A1 Mini are not fragile at all, neither the petals nor the pistil. Try again with good dry filament because I believe your rating is a bit low.
0
Reply
ok thank you
0
Reply
Replying to @Dane
Should you consider changing your evaluation ;)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill scale 50%
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill scale 50%
Strength Issue
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld