P1S rear panel belt dust cover v1.0
Copyright Claim
P1S rear panel belt dust cover v1.0
Boost
62
117
37
Print Profile(1)
PLA 0.16mm layer, 4 walls, 15% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
62
117
37
0
228
164
Released
Description
P1S rear panel belt dust cover v1.0
1. Function Description: This is the P1S chassis rear panel belt dust cover, which can prevent dust from entering, protect your belt, and extend the service life of the belt.
2. Installation instructions: After printing, install the parts marked with the letter L to the left and the parts marked with the letter R to the right. Press in firmly during installation.
Comment & Rating (37)
All
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
Other Issues:P1S 2024 model none of these covers on Makerworld fits. It seems like 2024 model back hole is much wider.
The designer has replied
1
Reply
在我的P1SC是2023年双12买的，之后的其它批次的机型，是否官方有修改就不清楚了，如果不适合你，推荐你多打印几个其它玩家发布的模型试试吧！谢谢！
0
Reply
Replying to @android88
There is a clearance issue; I will not pressure that piece to make the hole larger, that will mess the tension. So that tap you have in there needs to be less deep.
(Edited)
0
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
quick and easy print, fits perfectly
The designer has replied
0
Reply
Thank you very much for your recognition.
0
Reply
thx fits perfect also on the X1
(Edited)
0
Reply
Sadly it doesn't fit on a 2023 late model P1S.
Taps won't go in.
1
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
they are not very firm, perhaps it would be better with small magnets
The designer has replied
0
Reply
When installing, do not use too much force. Additionally, I do not recommend using magnets because many users do not have magnets in their hands, and there are many types of magnets that are not suitable for most users. Secondly, the motor is located in the belt position, and I am not sure if the magnet will affect the motor. You can modify the model to meet your personal needs. Thank you again for your suggestion!
0
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
i think they might not fit as good as I expected
0
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
Didn't fit perfectly, but was enough for cover it
0
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
Fits not perfrctly, but does its job!
0
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
works like a charm
0
Reply
Print Profile
PLA 0.16mm layer, 4 walls, 15% infill
bye bye dust
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld