Search models, users, collections, and posts
Corner clamp
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.8 h
1 plate
Open in Bambu Studio
Boost
60
139
1
2
108
29
Released
Description
90 degree corner clamp for wood working and fabrication, line up your corner joints perfectly for glue up or fixing.
Opening up to 75mm thick and to 0mm fully closed for a wide range of materials.
Required 2x m4 x 12mm cap head screws for thread block, some grease on slider and thread makes for smoother opperation.
perfect for diy and woodworking and best used in at least a pair. This is the slim version for better access to tight areas.
Prints in 4 pieces and able to fit all on a single plate, threaded actuator best printed with at least 6 walls for strength.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)