Dock for SanDisk Extreme SSD

Copyright Claim

Dock for SanDisk Extreme SSD

Boost
9
14
4

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
1.5 h
1 plate
4.8(4)

A1 Mini - 0.16mm layer, 2 walls, 10% infill
A1 Mini - 0.16mm layer, 2 walls, 10% infill
2.3 h
1 plate

Boost
9
14
4
0
29
16
Released

Description

Since I was asked for a variant of my “Dock for the SanDisk Extreme SSD with case”, I have now made this model. This model can now be used without the SanDisk Extreme SSD Enclosure with AirTag compartment.

 

With this dock, you have a nice setup for your desk where you can easily connect and disconnect your SanDisk Extreme SSD.

 

I have added some holes for two M4 threaded heat inserts. With these inserts, you can screw the dock onto your desk if you prefer a more secure fit. Alternatively, you can also use double-sided tape. You will be fine as well if you don't use either of these, for a more mobile solution.

 

For this dock, you will need:

  • 2x M3 thread heat inserts
  • 2x M3x7 screws
  • 1x 90-degree USB-C Adapter, this one to be accurate: https://amzn.to/3HntQcZ (Affiliate Link to support my work)
  • optional: 2x M4 thread heat inserts

The assembly is pretty straightforward. Install the heat inserts and then the 90-degree USB-C Adapter. Now, simply put on the bottom part, and you are finished.

 

Happy printing :)

Comment & Rating (4)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 15% infill
The print profile is good most of all. Few blemishes here and there on the extrusion. The size for the Sandisk is also a tad too big. Overall very happy. Thank you!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Quality is very good!! But unfortunately it exist different sizes of ssd and mine is bigger…
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
This is great for my 3 units.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more