This model allows you to mount a Bondtech LGX in a direct drive configuration on your Creality CR-10 Smart. This mount allows the strain gauge still to bend and allow leveling.
Step file and Fusion 360 archive included. Please adhere to the license and attribute.
2x M3x10 screwsIf using a reverse bowden mount to feed filament (recommended):
A PC2 bowden coupler
2x M3x10 screwsUpdate 2021-09-21: I found some reliability issues with the rev1 design. Updated
Printer:
Creality CR-6 SE
Rafts:
No
Yes
Resolution:
0.2mm
50
Notes:
You need a little bit of support for the part that screws into the X-carriage.
Assembly steps
Note: Prefer to use the direct drive interface plug.
1. Mount the LGX to the mount.