In this project i build a little shelf out of old laminate flooring and needed to pass through some charging cables. I designed this cable guide for up to six cables. The diameter of the passtrough supports cables up to 6mm.
the ring included is used so that the cables wont get dameged on the sawhole.
The guide is made for a 62mm diameter hole and a clamping range from 6 to 10 mm.
You can print this without support but after printing the thread needs some post-processing.
Use more than 2 walls to prevent infill in the shaft.
If i forgot to mention something dont hesitate to ask me.
+++Find the vent cover from the picture here: https://makerworld.com/en/models/188192#profileId-207391 +++