Carbon Rods Cleaner ultra light version
Remixed by
Copyright Claim
Carbon Rods Cleaner ultra light version
Remixed by
Boost
28
72
18
Print Profile(1)
Slim rod cleaner
Designer
17 min
1 plate
Open in Bambu Studio
Boost
28
72
18
4
184
134
Released
Description
Enhanced version of the carbon rods cleaner
- rounded entrance point for better snap onto the rod
- design holes in the body for less material usage and print time
- no supports needed
- only 2,5g of material
- simply better
Comment & Rating (18)
All
Print Profile
Slim rod cleaner
Profile printed well with Elegoo Rapid PETG.
1
Reply
Print Profile
Slim rod cleaner
Handy AND practical to print. Good job designing this to use so little filament 10/10
0
Reply
Print Profile
Slim rod cleaner
Too brittle around the logo cutout when removing any supports and couldn't get a nice enough print either if no supports were used.
The designer has replied
0
Reply
youre the first that has problems, reported for rating shooting.
(Edited)1
Reply
Print Profile
Slim rod cleaner
flawless print thanks for sharing
1
Reply
Boosted
Great! Thx!
0
Reply
Print Profile
Slim rod cleaner
Works great 👍
0
Reply
Print Profile
Slim rod cleaner
awesome thanks
0
Reply
Print Profile
Slim rod cleaner
Simple & efficient!
0
Reply
Print Profile
Slim rod cleaner
printed great!
0
Reply
Print Profile
Slim rod cleaner
1
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld