When you are relaxing at the pool or beach, needing to get up to throw something away can be annoying. Keeping trash around can attract birds and start smelling. With this reusable trash bag lid you can keep a trash bag nearby without the annoyance of an open trash bag. You can also dig a hole in the sand when on the beach and put the bag with lid in to secure it even better.

You can choose between 2 different lids depending on if you want a lid with or without trash!

SIZING: I printed mine smaller to fit on my smaller printer, but the original model is made to fit a 256x256x256 bed, but it can be scaled to fit your printer or trash bags

My printed surfaces may look bad because my printer is not that good unfortunately :/

Print with PETG or ABS to make sure the parts don't deform in the hot summer sun! 

Any feedback to improve the design and print profiles is much appreciated as this is the first time using bambu studio :D

ASSEMBLY

1. Take the lid of your choosing and click it into place with the outer ring (image 4 & 5)
2. Take your trash bag and put the outer ring around the top part. Make sure there aren't too many areas where the trash bags overlap as this might hinder the clamps (image 6, 7, 8)
3. Align the indent of the outer ring with the hinge of the lid (image 9)
4. Press the inner ring with lid into the trash bag and outer ring. When pressed correctly the inner ring should flex and click over the outer ring (image 10 & 11 without trash bag, image 12 with thrash bag)
5. You can check the connection by shaking the trash bag. If the parts fall of they didn't connect properly
6. The lid can be opened and closed with a click thanks to the lip
7. Enjoy your clean day at the beach/pool/anywhere else :)