muy practica y encaja todo de maravilla!!!

Tremendo. todo encaja perfectamente y es una gozada tenerlo todo bien organizado. Un 10 al diseñador.

printed great! awesome quality and design.

Printed great! only change I made was changed infill to gyroid, because gyroid sounds fun. this is only my second print so wasn't sure how to get the last layer to cover the magnets, didn't see it in the slicer. probably user error. very nice design, thanks!

Printed great although there seemed to be a slight layer shift (USER ERROR, read below)after the pause on plate 1(see last pic). I printed it twice and had the same issue but may be intentional. I also used the same magnets as you and they are pretty weak. They also rattle around. Any advice in that department. outside that a great case for Bambu accessories. Excellent work EDIT: USER ERROR above for. the magnet's, Icould have sworn they were 5x3 but after measuring with a calibrator they are 5x2 so should have measured before. For the layer shirts, it was so to changing speeds during the print combined with the pause. On the previous 2 I had switched the speed from normal to silent after the pause but before it started printing again. I left it on silent this time and walked away but it ran out of filements so it paused half way through and I changed speeds back to normal from silent during the filement run out pause and there is a layer shift there. odd, but I don't typically pause but I have changed speeds because the layer shift is EXACTLY where the filement ran out and I changed speeds. This one is odd but it's the same issue in different areas doing the same thing so I'm hoping it's that. it's not the file, that's for sure.

Thank you very much

perdon se me olvido subir esta foto recuerden la pausa del laminado para poder colocar los imanes

¿De que tamaño (diámetro y altura) son los imanes?

perfecta 👏👏

Holds hot end well but the wire holder should have been located on the other side of the hot end. Every time you place your hot end into this case you have to swing (bend) the wires the other way from the printer orientation. This leads me to be concerned about breaking a wire if you continuously are changing and putting them away in this storage box. Good print is why I still gave it 3 stars.