Bambu A1 bed handle

Remixed by

Bambu A1 bed handle

Remixed by
Boost
29
67
10
GIF

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
4.8(6)

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
23 min
1 plate
4.5(2)

Boost
29
67
10
1
76
46
Released

Description

Is your heatbed too hot to move? Print yourself this handle and don't burn your hands anymore.

When you put your plate on the bed, this front, sticking out part of it should be on the left side!

 

IF YOU PRINTED A COVER FOR YOUR SCEEN CHECK IF THEY COLLIDE!!!

This print does not require supports

Comment & Rating (10)

Please fill in your opinion
(0/5000)

When removed, it scratches the printer :sad-panda:
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed good on my A1 love that it’s a very tight fit but I’m disabled and don’t have strong hand grip so I couldn’t get it flush in the front but that’s a me problem not a print problem it still works for me so it’s ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
superb
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Kinda hard to install but it works very well !
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Es paßt nicht ganz!Aber sonst sehr gut. Danke
0
Reply
Thank you very much. I printed one to try. For bambu's original PEI board, one side fits 100% and the other side touches a little.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply