Reverse printing for week pill dispenser Remixed by T.giovanzana

Remixed by

T.giovanzana

Tools>Medical Tools

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

3.7 h

1 plate

5.0(4)

Open in Bambu Studio

Boost

Released

Description

This is a remix of the buttons.

I really like reverse printing, so I modified the original file to have a better looking when printed.

AMS needed

You may also like:

Comment & Rating (11)

@HotFix

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed using BL basic black PLA w/ Polymaker LM Show Green inside, all on the circle hologram plate. I think they came out amazing. Ignore the partially completed plate they are sitting in. The X1C clogged and though it finished. I have an issue where larger pills are getting stuck because the openings on these "buttons" are smaller than the opening of the pill repositories they sit in (see picks). I am pinging the original designer on that, but if you have suggestions, I'm all ears.

The designer has replied

@T.giovanzana

Amazing! unfortunately I had the same problems with large pills :(

(Edited)

@HotFix

Replying to @T.giovanzana :

I came up with a mod for the large pills: https://makerworld.com/en/models/373836#profileId-273843 I included a video to show the difference.

@T.giovanzana

Replying to @HotFix :

Hi I tried the same as your remix but unfortunately larger pills like softgel or tablets (not capsules) few times remain stuck because of the wrong inclination of the original model :( anyway thank you for the comment, I hope lot of people could find you remix helpful for their purposes