BLV AMS Riser with 8mm ledstrip channel Remixed by JP Creations

Remixed by

JP Creations

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 20% infill

Designer

163.3 h

11 plates

4.9(7)

Open in Bambu Studio

Boost

152

109

Released

Description

I made this remix of the BLV AMS riser by benlevi to accept 8mm ledstrips.

Its pointed towards the printer at an angle of 30 degrees to make sure most of the light goes direct into the printer!

All credits go to benlevi for this awsome AMS riser.

Comment & Rating (15)

@Aleks89

Boosted

Print Profile

0.2mm layer, 3 walls, 20% infill

Turned out nice. Had some issues with the radii but that's the nature of the design. The LED spacings are nice but due to a short cable, i had to drill a hole on the right side to find a way out for the USB-LED cable. All in all, nice and cool. Thx for the remix 😎💪🏻👍🏻

The designer has replied

@JPCreations

thank you for your feedback and make! looks awesome😁

(Edited)

@user_2309025454

Hey the drawers you have to the right of the printer in your first picture did you print those and if so I want to print those do you have a link or a design for them

The designer has replied

@JPCreations

heey! designed them myself😁 check out my page. they are all there😁

@user_2309025454

Replying to @JPCreations :

I see thank you now I have so much more to print LOL

@CheezyMane13

How does the addition of LEDs affect the onboard camera?, and time lapse?

The designer has replied

@JPCreations

its realy nice😁

@relensky

Print Profile

0.2mm layer, 3 walls, 20% infill

This is a great project. I struggled with the supports in the mounting holes for the TPU gasket. (they were a challenge to remove...) Overall, a great add-on! I used a 4mm LED strip to make teh installtion super easy. https://www.amazon.com/gp/product/B07K18HS94/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

@JeffreyBroekhof

Boosted

awesome design

@Boricstream5736

Print Profile

0.2mm layer, 3 walls, 20% infill

there was an issue with the supports for the pieces meant to be a seal between the original print and the top glass plate. The supports go too deep into the pinhole and are almost impossible to fully remove. I ended up chopping the pins off of the seal file, and I'm going to print it in TPU in an attempt to make sure that less noise is generated. the 3mf file that is suggested makes it so that the only TPU printed is in the buttons or the drawers and not for the seal which is confusing.

(Edited)