Print Profile(3)
0.2mm layer, 3 walls, 5% infill
Designer
2.5 h
1 plate
0.6mm nozzle, 0.3mm layer, 2 walls, 5% infill
Designer
2 h
1 plate
0.2mm layer, 3 walls, 5% infill
4.2 h
1 plate
Boost
138
193
22
3
218
171
Released
Description
3D Printable Camera Planter
Perfect gift for anyone who likes photography. You can fit up to 3 medium-sized succulents in it.
It can be scaled up without any major issues.
Personal use only. For commercial use see this link
Comment & Rating (22)
All
Print Profile
0.2mm layer, 3 walls, 5% infill
Supports were difficult to remove for such a simple overhang
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
perfekt. zum Beispiel als Handyhalter
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
Als Hobby-Fotograf perfekt sehr schönes Modell gerne mehr davon
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
came out good vary good for air plants
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
solid piece
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
Printed beautifully!
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
Strength Issue:when you take the support off the bottom of the lense easily broke off. when sitting down flat it is not noticeable
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld