Planter Vase for ForgeCore Monstera Coaster Plant

Copyright Claim

Planter Vase for ForgeCore Monstera Coaster Plant

Boost
281
423
15

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
Designer
7.2 h
2 plates
4.8(6)

A1 mini - 0.2mm layer, 3 walls, 15% infill
A1 mini - 0.2mm layer, 3 walls, 15% infill
Designer
11.9 h
2 plates

Boost
281
423
15
3
286
43
Released

Description

This model features a small secret compartment to stash things. Treat the Outer Vase as the “lid” when stashing things so that stuff doesn't get in the way as you screw it together.

 

It was originally designed around this Monstera Plant by ForgeCore. It's designed to fit the Dirt Base stl file included when you support ForgeCore on patreon.

 

Printing Instructions

No additional supports needed!

0.2mm layer height.

 

The stl's included should be oriented in the position they are meant to be printed in. The Inner Vase has built in support. It doesn't have to look pretty where it's supported as that's where the dirt/plant is meant to go.

 

It's recommended that you have your printer tuned for pressure advance and flow as the tolerance to insert the inner vase into the outer vase is only 0.2mm. I recommend cutting each model so you only have about an inch of each to see if they fit together.

 

If you plan on scaling both models down to fit a smaller plant, there might be a little leeway, but because the two parts screw together you might not have a good time if the scale is too small as they may bind together too much.

 

Assembly

Vase_Inner and Vase_Outer screw together

Comment & Rating (15)

Please fill in your opinion
(0/5000)

how can I change it to print in the Bambu lab A1 mini
The designer has replied
0
Reply
I've just added an A1 mini profile to allow you to do so. Let me know if you experience problems.
1
Reply
Replying to @Bearded.Printer :
you are a amazing my friend thank you!!
0
Reply
Replying to @Bearded.Printer :
I've checked and I'm missing the branches and the leaf or is it the same as other presets, cause in the A1 mini there are only the vase in 2 plates, sorry for the trouble
0
Reply
For those looking for access to the monstera model, The original (and best version) can be found on thangs: https://thangs.com/designer/ForgeCore/3d-model/Monstera%20Coaster%20Set-1029482
1
Reply
it needs magnets right, which size please
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
printed great
0
Reply
Has anyone had issues with printing the dirt base? I am constantly getting infill issues. I have printed everything else for ForgeCores Monstera model just fine, but now I can't get the dirt to print.
0
Reply
Boosted
nice design and idea with the campartment
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Great
0
Reply
hi it looks good
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply