P1S P1P Working Button

P1S P1P Working Button

Boost
17
42
4
GIF

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.16mm layer, 2 walls, 5% infill
0.16mm layer, 2 walls, 5% infill
25 min
1 plate

Boost
17
42
4
1
37
18
Released

Description

Button fit in the hole that works as a swtich, to control Led light or other electronics inside.

No need to remove any panel from the printer.

 

Use a 8mmx8mm self locking switch, three 5mmx2.5mm magnets OR some double side tape

 

Print the button house with the pin upward, no support needed

Print the button

Wire the cricut to you need

Fit in the switch untill it snap in

 

Install the house first, fit the pin to the small hole already on the inside metal panel

Install the button from outside, through the hole

Comment & Rating (4)

Please fill in your opinion
(0/5000)

is this connected directly to the printer or to a separate microcontroller that talks to the printer?
The designer has replied
0
Reply
This is just a button switch, I use it to turn on and off the additional LED light powered by the internal USB port. It doesn't control the stock light.
0
Reply
Very useful
0
Reply
Rate 4/5 Did this print but with own settings. Nice idea! Really like the funktionality. the base needs a little work because it is not easy to put in place and the magnets wont hold it against turning in the case.
0
Reply
No more