Storage Box for Portable Cable Organizer Skadis
Remixed by
Copyright Claim
Storage Box for Portable Cable Organizer Skadis
Remixed by
Boost
60
139
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, tree supports for hook
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
60
139
12
1
164
61
Released
Description
Hey! This is the third version of this storage box. This one is for the Ikea Skadis boards. It is also a little smaller and should fit the A1 mini.
Link to the Cable Organizer/Winder by squinn: https://makerworld.com/de/models/13849#profileId-13650
Link to previous Versions of the Box: https://makerworld.com/en/models/62199#profileId-64719
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
I chopped the hooks off this holder so I could use 3M command strips to mount it to my coffee table (didn't want to screw it). It works mostly OK - when I have the hinge side down (like in the picture) the holders rock a little bit. I think that's because the edge of the hinges are chamfered a little bit as they connect to the body of the cable organizers.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
Strength Issue:skadis mount needs to be 100% infill, broke the second I moved it
The designer has replied
0
Reply
sry to hear that. Mine is holding up pretty well so far, also had no complaints from other users. The surface on your picture doesn't look quite smooth? Maybe bad filament or problems with layer adhesion? Perhaps u give it another try!
0
Reply
Boosted
works great, I like the design.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
Workshop great - i raised the wall count that the hooks get 100% filling
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
Support issue I needed to print the skadis mount portion seperately and glue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
(Edited)
Other Issues:need support
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree supports for hook
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Related Models
© 2024 MakerWorld