outside measurement: 220 mm x 160mm x 160 mm

inside measurement: 200 mm x 140 mm x 140 mm

Multi part print to reduce adhesion problem

8 mm brim is recommended for the top, the bottom and the side parts

You will need:

14  x m5 x 40 mm screw

https://www.amazon.ca/dp/B097NWFQ8G?ref=ppx_yo2ov_dt_b_product_details&th=1

6 x m5 x 16 mm screw and 4 x 12 mm screw

https://www.amazon.ca/dp/B09LH81WB8?ref=ppx_yo2ov_dt_b_product_details&th=1

2 x 25 mm x 1.5 mm

https://www.amazon.ca/gp/product/B0B3M4621S/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1

epoxy to glue the side part to the corner

https://www.amazon.ca/gp/product/B077ZN8QBQ/ref=ox_sc_act_title_1?smid=AU8F11C75QMXL&psc=1

or you can buy it in every dollar store for cheaper

4 hair band

https://www.amazon.ca/-/fr/gp/product/B00DFSHD5O/ref=ox_sc_act_title_1?smid=A3DWYIK6Y9EEQB&th=1

Assembly guide:

1. Print the bottom first
2. Print the 4 corners 
3. Screw the 4 corners to the bottom plate with the m5 x 40 mm
4. Print the 4 sides 
5. Put glue in the female side of the joint
6.  Screw them to the bottom plate with the m5 x40 mm and hold it tight untill the glue is strong enough to hold the panel
7. Print all the handle parts (2 x handle side part and 1 handle center)
8. Assemble the top part of the handle first with the m5 x 40 mm
9. Use the 2 washer (one for each side of the handle) and screw the handle on both side with the 2 x m5 x 16 mm
10. Print the top part
11. Screw the 4 x m5 x 16 mm on the front and back side of the top
12. Print the 4 pins 
13. Place 1 hair band inside each of the 4 pins
14. Screw the 4 pins (2 on the front 2 on the back) with the 4 x m5 x 12 mm