Z-Axis Lead Screw Full Dust Cover
Remixed by
Copyright Claim
Z-Axis Lead Screw Full Dust Cover
Remixed by
Boost
23
48
34
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
PETG - Brim - No Fan - 0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
23
48
34
0
125
108
Released
Description
Lightweight full dust cover for the z-axis lead screw. If your build chamber tends to get very hot, I recommend printing in PETG or a filament that is good at resisting deforming at higher temperatures.
Benefits:
- Prints in 16m, 7g of filament
- Mirrored design works for both left and right side
- Doesn't block the preinstalled camera
- Doesn't hit the built plate
Update 2024/03/23 - Added a new profile to help with prints lifting off or warping. Tested using PETG, this profile adds a brim to keep the parts down, and turns off the Aux fan to avoid the closer piece lifting.
---
Includes the FreeCAD project used to create the design (including Loonie reference image)
Comment & Rating (34)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
easy and fast :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect fit and a great file. thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice and simple.
Thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Ok
0
Reply
Perfect fit !
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:they don't fit at all, and bend every easily
The designer has replied
0
Reply
Can I ask what machine you tried to install them on?
0
Reply
Replying to @JamesRagnar
on my x1 carbon
0
Reply
Replying to @Dude3D
Interesting, from what I've read that should have the same dimensions as the P1S that I tested this on. If it's a sizing issue I could take a stab at updating the model to fit the X1C.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very loose fit for me when printed with ASA, needs adhesive or something to not wiggle during printing. Maybe just needed a higher flow rate
The designer has replied
0
Reply
Yeah sounds like it was lifting while it printed, may have impacted the sizing. I don't have any ASA on hand at the moment but I added a new profile tested with PETG, it adds a brim and turns off the aux fan so it should help prevent warping.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfektní, velmi dobře pasuje!!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works great and looks great!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
These are so good. Stops all the dust and bits of filament from getting in to the bearings. Nice.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld