Lead Screw Cleaner
Copyright Claim
Lead Screw Cleaner
Boost
62
113
15
GIF
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
Designer
22 min
1 plate
Boost
62
113
15
3
144
83
Released
Description
Be sure to check out my V2 version.
This is my version of a fairly precise cleaner.
To fix it, make sure that one of its halves is in the thread and then press the other half until it clicks (example in the gif). It is advisable to put 1 layer of paper towel under it. You can also use 2 layers, but then it is more difficult to snap the cleaner. The two protrusions on top are designed to facilitate fixation on the third screw opposite the door using narrow pliers.
Comment & Rating (15)
All
Print Profile
0.16mm layer, 3 walls, 15% infill
Printed great from Handy app.
The designer has replied
0
Reply
I hope to read later that it works great, because that's much more important)
0
Reply
Replying to @VkvitV
Yea i'm in no rush, i cleaned the rods like a week ago :) will post back!
(Edited)1
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
perfetto
The designer has replied
0
Reply
The gap seems too big. Did you snap the halves together all the way? You may need to squeeze quite hard the first time.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
Boosted
Print Profile
0.16mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld