Ladybug and Bee Magnetic cable organizer
Remixed by
Copyright Claim
Ladybug and Bee Magnetic cable organizer
Remixed by
Boost
32
66
11
Print Profile(2)
LadyBug_Ø4mm_0.12mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Bee_Ø4mm_0.12mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Boost
32
66
11
0
77
57
Released
Description
Cute little animals magnetic cable holders
These little animals are perfect for a desktop lawn:
https://makerworld.com/en/models/158883
Neodymium magnet Ø5mm and height 3mm required.
Printing profiles for cables with a diameter of Ø 4mm. For cables with a smaller section it is sufficient to make a few turns with adhesive tape (Scotch) to slightly increase its volume.
Enjoy! ^_^
Comment & Rating (11)
All
Print Profile
Bee_Ø4mm_0.12mm layer, 2 walls, 15% infill
printed great
The designer has replied
1
Reply
thank you!
0
Reply
Print Profile
LadyBug_Ø4mm_0.12mm layer, 2 walls, 15% infill
Were cute. Not sure about wire snap part of it, but will work it out
The designer has replied
1
Reply
Thank You!
0
Reply
Do you also fix magnets to the inside of the lawn organizer?
The designer has replied
0
Reply
Yes, if you want to use this way to store cables not in use it is necessary to insert 10mm diameter magnets inside the container vase, and other smaller magnets inside the bee or ladybug.
Otherwise you can install the bees and ladybugs on the cables without magnets, they will only do the aesthetic part and not the functional one.
0
Reply
Replying to @TheMiguelBi
awesome that's what I had guessed, thanks!
1
Reply
Print Profile
LadyBug_Ø4mm_0.12mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
LadyBug_Ø4mm_0.12mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Bee_Ø4mm_0.12mm layer, 2 walls, 15% infill
1
Reply
Print Profile
LadyBug_Ø4mm_0.12mm layer, 2 walls, 15% infill
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld