I remixed the P1P iPhone mount (i dont have an iPhone) for use with a hot shoe universal phone holder I did have. This allows me to use any phone or pretty much anything that uses a hot shoe mount. A more universal option. This was also made to clear the Arc Enclosure and JJDeluxe73's Top Lid Riser.

There are three versions, one is the original, if you dont run the arc enclosure to save material and the 2nd version I extended the corner to aesthetically match the side of the corner of the arc enclosure. Ideally I would have liked to match the corner around to the front by bring that out like 3mm or so (so it still clear my Bu Faceplate) but I haven't gotten around to that yet so perhaps I'll do that at a later date if someone else doesnt first.

**The 3rd version adds a small support leg to the edge. I found that when I mounting heavier things like a tablet, after awhile the press fit tab just wasn't holding given the uneven weight off the edge. This extra little support leg should help keep the mount from being allowed to tilt caused by the heavier object mounted over the edge.

Print on side with supports for plug and hotshoe overhangs