Moss pole/holder for propagation pot
Boost
29
51
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
2.5 h
1 plate
Open in Bambu Studio
Boost
29
51
8
1
58
14
Released
Description
Moss “pole”/holder for moss propagation pots. Fits snuggly in-between pot wall and dirt. Can be installed after plant has been planted in pot
Comment & Rating (8)
All
Mine did not print so snug, its a bit loose, im going to find another solution to get it to stay together a bit better. perhaps some super glue or a few small zipties.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I'd love to see this have an extendable option! I did print it and it's lovely but my plants are way too big!
The designer has replied
0
Reply
How much are you looking to extend it? double the height? 1.5x?
(Edited)1
Reply
Replying to @DJMOJO
If it was modular I'd be able to use it for some of my plants that are 2-3 ft. Most of my plants are on round moss poles. I love the look of this one. I'd like start a philo on this design and would hate to move it to another moss pole once it's established.
0
Reply
You can't extend it, can you? So that it basically grows with the plant.
1
Reply
How much are you looking to extend it? double the height? 1.5x?
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
For people saying its a little loose, that is only when empty. Once you put your growing medium in the base, the moss pole extension works great. I am using it for growing my Pink Princess Philodendron.
2
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld