Rigid modular moss pole plants (sphagnum, coconut)

Copyright Claim

Rigid modular moss pole plants (sphagnum, coconut)

Boost
181
453
59

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, fast print, every part optimized
0.2mm layer, fast print, every part optimized
Designer
3.8 h
4 plates
4.9(49)

Open in Bambu Studio
Boost
181
453
59
67
517
354
Released

Description

Rigid modular moss pole for houseplants (can be filled with sphagnum, coconut fiber)

1. Moss pole
2. Groundtip
3. Top cap
4. Clip for securing the plant

Tested over the years, the best for printing in PLA.
Ready-to-print profiles attached

Thanks to its strong connectors, it allows strong support even for large plants. As the plant grows, we tighten further modules to extend.

Comment & Rating (59)

Please fill in your opinion
(0/5000)

printed with PLA. good work
The designer has replied
1
Reply
enjoy :) great quality
0
Reply
perfect design ! i already printed 8 poles and my girlfriend ask for more =) good job now i most look for a slow drip irrigation / watering system design thats fits the same thread
1
Reply
Print Profile
0.2mm layer, fast print, every part optimized
Nice project. Thanks!
0
Reply
Print Profile
0.2mm layer, fast print, every part optimized
The printing and preparation of the data is very good. The thread is a bit loose for me but it holds. 👍
0
Reply
Boosted
Best designed pole on makerworld!
The designer has replied
1
Reply
thank you very much for your appreciation
0
Reply
ATTENTION! I must correct myself, the text below is incorrect! My slicer automatically added supports that, according to the original file, do not belong to the rods! It works significantly better now! I printed four rods and unfortunately they all break immediately when attempting to remove the supports. I used PLA as described.
(Edited)
The designer has replied
Show original
0
Reply
yes :) supports must be disabled
(Edited)
0
Reply
Print Profile
0.2mm layer, fast print, every part optimized
Top quality, prints well
Show original
0
Reply
Having thread issues on the caps. I am using PETG, will not use PLA for this. Threads only on the caps seem to be too small/improper fitament.
0
Reply
Print Profile
0.2mm layer, fast print, every part optimized
PLA not completely connecting when nozzle cleans towards end of pole printing. Small amount of tension sheered off the top of pole. Was able to reattach with glue. Not a one off event - I printed 2 poles and both had same issues but in slightly different locations on pole. As I’ve mentioned I am new to this so if it’s user error then I apologise. Thank you
0
Reply
Thanks!
0
Reply