πMiga - Raspberry Pi 4 case
Copyright Claim
πMiga - Raspberry Pi 4 case
Boost
3
9
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.3 h
3 plates
Boost
3
9
3
0
12
3
Released
Description
A case for a Raspberry Pi 4 + SSD drive inspired by the classic Amiga 4000 look.
To get the led and the switch working in Raspbian, you need to change /boot/config.txt adding the following lines:
# HD led
dtoverlay=gpio-led,gpio=8,label=hdled,trigger=mmc1
# power indicator
gpio=4=op,dh
# start a system shutdown when the button is pressed
dtoverlay=gpio-shutdown
Connect the LEDs and the switch to the above mentioned GPIO pins.
BoM:
- 5 M3 screws (4 for the SSD, one to block the top part of the case)
- 4 M2.5 screws for the Pi (unless you prefer to use my “pi blocker”)
- 4 6x3 magnets for the front plate
- 1 green 5mm LED
- 1 yellow 5mm LED
- 2 330Ω resistors
- 1 6x6mm tactile switch
- some wires
Comment & Rating (3)
All
Wish I had a pi to put it in! I remember back in 1987 my dad got us an Amiga 500!
I took one look at it, at the age of 5 and thought, THIS IS THE FUTURE! :)
The designer has replied
0
Reply
yeah, it was way ahead of its times back then :-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld