Search models, users, collections, and posts
Milwaukee M18 Battery Holder for Omniwall Pegboard
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.6 h
2 plates
Open in Bambu Studio
Boost
6
38
1
3
39
22
Released
Description
Modified from IndomReps excellent Milwaukee M18 Battery Holder.
https://makerworld.com/en/models/44353-milwaukee-m18-fuel-tool-battery-mounts#profileId-45892
Designed for the Omniwall pegboard system with mounting holes on a 1in spacing vertically.
Print in a VERTICAL orientation for support free prints!
Plate 1 - Has battery clips so you the battery latches in and could be mounted upside down if desired.
Plate 2 - NO battery clips so the battery slides in and out easily, but can only be mounted with the battery being removed upwards.
Tested with PETG and PETG-CF.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)