A1 Top-side-mount Spool Holder with AMS Lite
Copyright Claim
A1 Top-side-mount Spool Holder with AMS Lite
Boost
249
568
146
Print Profile(7)
right side spool holder
Designer
2 h
1 plate
left side spool holder
Designer
2 h
1 plate
More Walls. Less infill, 0.2mm layer, 6 walls, 25% infill
2.7 h
1 plate
More Walls, Less Infill, 0.2mm layer, 6 walls, 25% infill
2.7 h
1 plate
Click to see more
Open in Bambu Studio
Boost
249
568
146
29
988
693
Released
Description
(EN)
A solution to climb the spool holder with the AMS lite attached at the top.
One profile for the left and one for the right side.
(DE)
Eine Lösung den Spulenhalter bei oben angebrachtem AMS lite zu befestigen.
Ein Profil für die linke und eins für die rechte Seite.
Comment & Rating (146)
All
Print Profile
right side spool holder
developed a slight crack when mounted
simple fix with glue and zip tie
3
Reply
Print Profile
right side spool holder
print with gyroid 5% and 3 walls. good rigid.
(Edited)
The designer has replied
0
Reply
Use one of the AMS lite PTFE tubes. that fits! 😉
0
Reply
Replying to @lisner.martin
Oh! so i have to remove one from my ams. Thanks mate.
0
Reply
Boosted
Print Profile
left side spool holder
Works with extra zap strap support.
1
Reply
@Hoju you have the spool mounted the wrong way, you shouldnt need zipties
0
Reply
Print Profile
right side spool holder
Printed well, I like the support placement. It fires a little loose on my A1, and can fall off if I’m not careful pulling the spoil off. It would benefit from a compliant latch on the backside to prevent that.
Great idea though! I’m gonna enjoy having my external spool back for TPU. It’s a pain to switch the AMS on/off, this will save that headache.
1
Reply
Print Profile
right side spool holder
Very usefull model
1
Reply
Print Profile
right side spool holder
This thing is great. Just wait I needed.
1
Reply
Print Profile
right side spool holder
Is good and easy to vše and print i Havel one question ist load a 1kg filament without problém?? thanks
1
Reply
Print Profile
left side spool holder
I printed it vertically to avoid layer issues.
The design seems ok for now but I wish there was more instructions by OP on how to slide the holder into place without having to force it, or how the Bambu holder can be disassembled to switch side so that this holder doesn't have to be secured with a zip tie.
0
Reply
Print Profile
left side spool holder
Printed in PETG, super strong and works perfectly. Small issue with overhang but could be a calibration issue on my printer).
0
Reply
Print Profile
left side spool holder
Picture show spool on tight side, but it is fpr left side, and broake befor use, layser seperation
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld