AMS Lite PTFE Protector and Numbers
Remixed by
Copyright Claim
AMS Lite PTFE Protector and Numbers
Remixed by
Boost
14
24
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
14
24
10
0
42
33
Released
Description
Really liked the model by Wojciech Kawa and after printing it I noticed how much the PTFE tubes wiggle while printing. So I added a piece to try to stop a bit of the harsh movements with the PTFE tubes.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
this was excellent design both functionally and visually. you can customize your colors with the AMS so that you can see the numbers easier and still see the lights with no problems. this design also gives nice support for the tubes and stops them from shaking so much.
0
Reply
the print went perfect right from the ap. it's a perfect fit and the tube support is great! thanks man
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice design, but it is a little bit tight and the cover of the motor is bending.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
they turned out better than expected
0
Reply
printing now. do they snap onto the old numbers?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld