Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA PolyTerra Charcoal Black
PLA HP3D Red
PLA HP3D Yellow
PLA BambuLab Basic Jade White
Swap Instructions:
Start with Charcoal Black
At layer #9 (0.8mm) swap to Red
At layer #14 (1.2mm) swap to Yellow
At layer #18 (1.52mm) swap to Jade White for the rest.
Hueforge Affiliate: https://shop.thehueforge.com/?aff=6
Patreon: https://www.patreon.com/NeoKoiPrints
Youtube: https://www.youtube.com/@NeoKoiPrints
Tiktok: https://www.tiktok.com/@neokoiprints
Instagram: https://www.instagram.com/neokoiprints