Angry Lugia Portrait (HueForge)
Copyright Claim
Angry Lugia Portrait (HueForge)
Boost
33
53
8
Print Profile(1)
0.08mm layer, 3 walls, 100% infill
Designer
5.1 h
1 plate
Boost
33
53
8
0
41
23
Released
Description
Hi everybody! I'm exploring a new modeling technique using Hueforge, and this is another model! 😊
Credits: https://www.pinterest.it/pin/838584393142478552/
Enjoy it and please rate ⭐⭐⭐⭐⭐!"
Comment & Rating (8)
All
Print Profile
0.08mm layer, 3 walls, 100% infill
this printed really good. it did have a small bit misprint on mine, but that’s more down to luck than any flaw in the print or profile.
0
Reply
Hi! where can i find the suport? thanks
The designer has replied
0
Reply
Here https://makerworld.com/models/389470
1
Reply
Replying to @BigSimi
thank you very much!!
0
Reply
I'm having the best results with these by turning the initial layer speed down to 30mm/s. at 50 the corners sometimes peel up and don't look nice. a brim can help too if you don't mind removing it and giving the edges a little sanding.
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
nice
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld