Fume extractor for the rear chamber fan of the bambulab X1C and P1S printer (also P1P), this version is based on the work done by @Wolfie3D_373632

Compared to his version, I made some changes by inserting:

• 38 neodymium magnets 5x2mm
• 8x3mm gasket to seal the edges

The locations for the magnets were made to fit perfectly, however I preferred to add a little bit of superglue

I kept the screw holes in case someone needs to use them

The fume extractor kit I used is as follows https://www.aliexpress.com/item/1005005953853839.html; and the magnets used are these https://www.aliexpress.com/item/1005006079484771.html

The superglue that i used is this https://www.aliexpress.com/item/1005005266360949.html, I used it both for the magnets and to stop the tube inside the adapter