A simple cord organizer I designed for my quest and headphones.

• Outer dimensions are roughly 100mm x 31mm x 26mm.
• Inner dimensions for cord well is 100mm x 12mm x 12mm which
• holds maybe 4-6 cords (scale if needed for more cords but get bigger screws as well).
• Requires holes to be drilled (or maybe sticky pads but I havent tested)

This is my first original print in place with hinges. It snaps closed and a small handle to make it easier to open. It shuts pretty snug but not hard to open as well.

Printing/assembly

• I print with bambu studio default .2mm profile.
• It is a single print in place piece
• After printing close it to free up the hinges - you will feel a little crack the first time
• It requires 2 wood screws. I used size 4 imperial and 7/64 inch drill bit.
  • The screw holes in the model are precisely 4mm in diameter
  • I have not tried with metric screws so maybe m3 or m4 would work.
  • You might be able to use sticky pads if you dont want to drill holes but I havent tried it