Lower Profile Remix Plate Holder P1P, P1S, X1, X1C Remix
Remixed by
Copyright Claim
Lower Profile Remix Plate Holder P1P, P1S, X1, X1C Remix
Remixed by
Boost
4
8
5
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
A1 Mini 0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
4
8
5
0
18
12
Released
Description
Hello
i have noticed that my printer higher on the side where the original holder is. maybe im the only one, since I couldnt find a comment on that here.
I have remixed that model to fit my printer better. I have printed it in PETG.
The one picture it the original model, you can see that the printer is lifed on one side. The Remix picture shows that the printer is now even on both sides.
I have reducted the hight from 6,2mm to 3,2mm
see original model for assembly instructions.
Comment & Rating (5)
All
I had some issues with the model, either printed in PLA and PETG. Since my X1C was lifted with this holder. I have added a remix of the original that is lower. If the lifting was intended I will revoke my remix.
if not it might help some that have the same issue as I do
the plates fit well either in PLA or PETG
0
Reply
Awesome remix! Thanks for sharing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld