Govee H5075 Digital Hygrometer Thermometer Door Mount For Bambu Lab P1S
Remixed by
Copyright Claim
Govee H5075 Digital Hygrometer Thermometer Door Mount For Bambu Lab P1S
Remixed by
Boost
12
15
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, minor supports
34 min
1 plate
Boost
12
15
3
0
20
6
Released
Description
Mount your Govee H5075 Digital Hygrometer Thermometer onto the door of your Bambu Lab P1 Series or X1 Series printer to conveniently monitor the enclosure's temperature and humidity.
Comment & Rating (3)
All
Warning, do not print this and install it if you are using the stock Bambu build plates. The hygrometer + this mount are too thick and will interfere with the plate as it rises.
The designer has replied
0
Reply
the stock bed is double sided and you can just flip it to avoid contact. This print was great and I don’t think it needs the warning.
0
Reply
i know this is an issue so i eventually switched to using a modified version of this https://makerworld.com/en/models/19602?from=search#profileId-18329 with the clip at the top removed and instead i simply used a small amount of super glue to attach it to the front panel next to where this model would be mounted as i found it was difficult with the filament i had to not have slight sagging over time from the section where the door handle screws attached, only a small amount of glue is needed and can be safely removed using the bed scrapper if you no longer want it mounted there without it causing any damage to the glass
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld