A box for your Nikon Z needs.

Neatly stores 4 Nion EN-EL 15C batteries, 4 XQD/ CF-Express B and 4 SD cards.

If you want it to seal, use a piece of 1,75mm TPU filament, cut it to length and join the ends with ca glue, for example, to create a full loop.

Logo is added as a shallow extrude so you can paint it in the slicer using the fill bucket tool - if you don't color it, it won't show up in the print at all.

There's a 5 mm gap between the batteries/ cards and the inside of the lid. This allows you to add a piece of foam or similiar.

The battery holders have the connector part cut out in the bottom, so you could have empty batteries up side down and still have them sit correctly.

Latch and hinge uses a total of 3 M3x30 screws

Update 23/02/24

Added Version with 2 Batteries and 2 Card slots

Added Version with single Batterie and 2 Card slots