Trevors AMS Helper
Remixed by
Copyright Claim
Trevors AMS Helper
Remixed by
Boost
3
3
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Boost
3
3
1
0
11
4
Released
Description
AMS helper. Shorter to fit new AMS. I used the one from 42 Labs 3D which is 5mm shorter than the original but it was still a little too tall for mine. Filament was being pinched between lid and guide. I lowered the location of the SS rods to allow clearance and keep it centered between the edges.
Pins I used are from amazon. 4mmX25MM SS pins.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Ne sehr gute Idee. Aber bei Sunlu pla rollen passt es nicht, da blockiert es die Rolle. Schade eigentlich
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld