Standard Caliper Hanger for Hex System HSW
Copyright Claim
Standard Caliper Hanger for Hex System HSW
Boost
17
52
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
17
52
16
0
117
74
Released
Description
This is a caliper hanger for the HSW hex system. There are a couple others I found on makerworld however mine prints flat on the build plate for a precise fit without support at the hex. Support is still likely required on the angled sides that support the caliper jaws.
Comment & Rating (16)
All
A bit too tight for my caliper, but it'll do for now. Thanks for the model!
The designer has replied
0
Reply
Thanks for the feedback. Is it the width where the caliper body fits? Maybe I can loosen that tolerance a little and post a revision.
0
Reply
my harbor freight PITTSBURGH calipers did not fit and snapped the print almost immediately. its not wide enough. printed great though
The designer has replied
0
Reply
appreciate the feedback. I am going to revise the file to be wider. I think harbor freight must’ve changed suppliers or at least have more than one
0
Reply
I increased the opening width by 3mm so hopefully it works for your calipers now.
1
Reply
Replying to @cmcraig2
oh excellent! ill print one when i can and test. using petg this time lol
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print is good, but it was too tight for my caliper
The designer has replied
1
Reply
Increased width by 3mm now.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super👌
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld