Introduction

I designed these as I've had a few requests for bowls after I released the “HSW round shelves” model. You don't need a HSW (Honeycomb Storage Wall) to use them as they have flat bottoms.

The size denoted is the widest part inside the bowl. You can visualise it on your wall by importing a wall piece and the bowls in the slicer and arranging them in there, this will help you select the right bowl sizes. You can also use the measure tool within the slicer.

If you can't put holes in your wall to mount a HSW, check out this free-standing variant (if you can't print this, you can put these feet onto a regular wall piece! I am working on other sizes of free-standing ones too).

Material

• Suggest PLA, ASA, ABS, PETG-CF or similar stiffness materials.
• If you use PETG, the clip will be a little too easy to remove and
• If you use a stiff material like ASA-CF or ABS-GF, the clip will be difficult to insert/remove.

Print settings

• 3 perimeters
• There should be enough bottom layers to ensure that the bottom of the bowl is completely solid. Just set the bottom layers to 10. (Note that the bigger bowls have thicker bottoms)
• Paint your seams so they are less visible (look at the white dots in the sliced preview)
• I suggest slowing down the outer walls to ensure the part comes out strong with consistent gloss level all around (but this is optional)

Support

You can support me by simply doing one of these things:

1. Please post a make! Lets see your HSW setup.
2. Share it on socials!
3. A boost?
4. And if you're feeling extra generous, you could buy me a few metres of plastic on Ko-Fi

Check out my other HSW models in this collection.

The little dragons in the picture are by Zou3D and the big dragons are by Cinderwing - they are both amazing - check them out!

Thank you and enjoy.