A1 Poop Deflector / Baffle
Copyright Claim
A1 Poop Deflector / Baffle
Boost
26
58
32
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
8.1 h
3 plates
0.16mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Boost
26
58
32
0
136
99
Released
Description
There are a lot of variations of buckets, deflectors, etc. I like the simplicity of this deflector without having a large bucket etc. but those that I tried didn't quite work, or the filament would stick to the deflector. I created this one from scratch and included an angled face so that there wasn't a flat surface to hit and stick to. I've tested it a number of times and nothing sticks to the deflector (see pictures).
I was going to create my own buckets, and might still, but the buckets from Slim A1 Poop Bucket Extended by Encrust3d - MakerWorld are nicely done and just remixed them to remove the taller side wall.
Comment & Rating (32)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Perfect, thanks a lot for this useful print!
The designer has replied
0
Reply
Awesome, glad it worked out for you!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed perfectly, didnt test if it works yet but very nice model!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Fill perfect!
(Edited)
0
Reply
printed great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The poop was sticking to the back surface and did not fall down
(Edited)The designer has replied
0
Reply
did you print with .16? I've not had anything stick to this one. Also, if the filament / nozzle temperature is very high, might need to print with PETG to avoid very hot PLA sticking. I have yet to have anything stick after a week of solid printing.
(Edited)0
Reply
Replying to @JeffSmith
I just used the default setting with your .2 model using Bambu labs light blue fulfillment. I will try it again using your .16 model
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great quality
The designer has replied
0
Reply
Thanks for the review! Curious why "great quality" is 4 stars?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works perfectly with the bucket below it.
The designer has replied
0
Reply
Glad to hear it! :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great. Fits snugly without cracking, an issue on some others I have tried.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld