I wanted a door handle that extended further out but not too much so that it was easier to grab and pull. But mostly because I wanted one that had the Bambu Lab logo graphic to kind of match the top glass handle. These models where originally posted to printables.com (October 29, 2022).
I printed it using PETG but any filament should work. If you want to print the logo using a different filament color, if your using the Bambu Studio I find it easier to paint the logo by splitting the model “To Parts” then in the “Object” mode select each logo part and select the color from the filament dropdown menu.
Layer height: 0.16mm
Wall loops: 3
Infill top surface pattern: Hilbert Curve (Looks Cool!)
Support - Enable support: Yes please!
Support Type: normal (manual)
Support Painting: support fill paint the bottom of the screw post
Files: round and square versions with flush, inset, and extruded logo.
Warning: Be careful when you screw on your new door handle in that you don't over tighten it as you may crack the glass. Make sure that the tiny washers are still on both sides of the screws.