This is a cable holder for the Bambu Lab A1 which is attached to the upper X axis to keep the AMS cable outside the printing plate and the printing area to prevent damage to the cable or the component.

The holder was printed from PLA grey, the strength of the material is sufficient as it is not mechanically stressed.

The following parameters were adjusted in Bambu Studio:

• Thickness: Wall lines: 3
• Thickness: Filling pattern: Gyroid
• Support: Support stuctures active
• Type: Tree, Support critical areas only
• Other: Border type: No border

I wish you lots of fun and success with printing.

Your Techmo3D Techmo3D (@techmo3d) • Instagram-Fotos und -Videos