Every month, we shout out the most helpful members of #PrintClinic — the ones who give clear, actionable, and friendly advice that actually gets prints unstuck.

Meet this month's 3 Gold Medal Doctors and their standout cases 👇

How We Pick Them (Quality > Quantity)

We're not rewarding reply spam — we're looking for answers that actually fix prints:

✅ Accurate diagnosis — nails the root cause, not just the symptom

✅ Actionable fixes — real settings, real steps, reproducible results

✅ Confirmed fix — the OP (original poster) comes back to say it worked

✅ Beginner-friendly — patient tone, no gatekeeping, no jargon dumps

🏆 This month’s Gold Medal Doctors

🥇 Doctor: @waylaidwanderer

Specialty: Stringing / filament tuning / PETG troubleshooting 

June track record: 244 helpful replies · 35 confirmed fixes

Featured case: "PETG keeps leaving little nubs on print walls"

From the photos, those bumps look like PETG oozing during travels and getting deposited back on the surface — not random slicer glitches. Even if you dry often, PETG stays hygroscopic. Try this order:

1. Dry it properly first: active dry at 65°C for 6–8 hours in a dedicated dryer — "regular drying" often isn’t enough;
2. Lower nozzle temp: try 240–245°C so the material is less runny;
3. Slow outer walls: reduce outer-wall speed to ease pressure in the hotend;
4. Enable wipe settings: turn on retraction wiping / outer wall wipe in Bambu Studio.

Why they made the list: Asks for details first, then delivers a full PETG oozing playbook with exact temps and slicer toggles — the kind of answer you can follow step by step.

🥈 Doctor: @UltraModern3D

Specialty: First-layer adhesion / bed maintenance / multi-color slicing 

June track record: 89 helpful replies · 9 confirmed fixes

Featured case: "Prints detach mid-print — especially articulated models"

When small parts lose grip halfway through, it’s usually a bed adhesion / plate condition issue — not always "wrong settings." Try this order:

1. Clean the build plate: wash with warm water + dish soap, rinse, dry fully;
2. Flip the plate: use the other side if one face is worn or oily;
3. Replace if needed: if cleaning + flipping don’t help, the plate may be done;
4. Follow up: OP liked the answer — UltraModern3D always invites questions after the fix.

Why they made the list: Short, on-target, and actionable for the most common adhesion failure path — clean, flip, replace — without overcomplicating it.

🥉 Doctor: @A-A-ron987

Specialty: Model & slicer diagnosis / support strategy / closing the loop 

June track record: 19 helpful replies · 11 confirmed fixes

Featured case: "Card stand looks stringy — but is it really stringing?"

From the photos, that area is an extreme overhang — the bundled profile likely shipped without supports, not a retraction/temp issue. Try this order:

1. Enable supports in Studio — open the model in Bambu Studio → Quality tab → turn on supports → Slice → Print;
2. Follow up after the reprint — areas where supports were removed may not be perfectly smooth; check for a grid pattern — no grid means supports are fully off;
3. Skip the purge tower — this print only needs one color change; disable the tower in Studio to save filament.

Why they made the list: Gives click-by-click Studio steps, then follows up after the OP’s result with cleanup + purge-tower tips — textbook closure.

💬 Put on the white coat — join #PrintClinic

Browse #PrintClinic, find a question you know how to answer, and share what worked for you.

Your one quick reply might be someone else's "finally, it printed!" moment 💊

Next month's Gold Medal Doctors list could have your name on it.