Beautiful design and printed fine first try using the default profile. Sad to see a few negative ratings on this for what is likely just people needing to clean their build plates.

This was my first attempt at "aging" a print and I absolutely love how it turned out. There are no instructions for the build but it's all pretty straightforward and well designed for assembly. the supports on the .12 profile came off like butter. Thank you!

Thank you!

Absolutely gorgeous results. Even the prime tower looked pretty. Thank you!

Thanks!

Printed beautifully. Thank you!

Exactly what I needed! Nice design!

Perfect, minimalist design to mount the light cleanly to a skadis board. I use it to keep a portrait of my dog lit up.

Excellent quality print!

Excellent design. protip for the tail supports: cut away 90% of them first before trying to break them free from the tail. there's less leverage and it decreases the likelihood of breaking the tail off.

Beautiful.

Printed clean on a Damascus steel inspired plate. Thank you!

Very nice print! I printed in yellow PETG because I have a bunch of extra. primed it with flat black Rust-Oleum and then did a rub and buff on it.

I've made probably 6 of these for friends, but finally got around to making one for myself and actually putting lights in it. Made a small hole in the back plate for the cord in the slicer and other than that, didn't really have any issues. Thanks!

Perfect fit. exactly what we needed. Thank you!

Beautiful. I've been printing for almost 8 years and have had this old roll of TPU laying around for about that long. Dried it for 6 hours today and this was my first ever print with TPU and it looks great! Thank you!

Printed great in PETG. My front door faces the rising sun, so I'm hoping that PETG holds up better long term as opposed to PLA. The message of this sign is perfect. I think the "no solicitors except girl scout cookies" signs are funny, but I'd legit feel bad if a kid was selling candy or something else and turned away. I'm always down to buy candy or whatever when kids are trying to raise money. I'll usually try to buy them out of whatever they got left if it's reasonable. Solar salespeople have been relentless lately though.

Excellent design. I got an IKEA LED I had laying around into the base without much issue. I need to cut a little bit out of the base so it fits the cable end better, but it's working great. Thank you!

Be careful printing this profile on an X1C. The top part of the lid will print over the purge line. Otherwise it was good.