I printed out a bunch of these to help organize some kitchen drawers it was really helpful to get some sizes for different kinds of kitchen tools, I ended up creating boxes to replace these as they were a bit flimsy for long term use.

Worked great, I got a little over zealous and printed 5 drawers on a slant to get them printed sooner so the fronts don't all look great, but they work. So this is not an issue with the print. I added the Death Star knobs just for ease of use, see Deathstar knob/handles by noordinaryleaf. I also cut out the back top edge on the 2 drawer unit to allow for the extra length of my Esun filament drier to fit. looks good and works great.

I used the laser to engrave it in the positive and negative versions, looks really good

This set of boxes and drawers print very well. I am currently in process of setting up my work area

This printed well, however the plug end wont screw in to the handle, I tried two times, the tool end will screw in to both ends of the handle. I'm not sure what is happening. There is a slight bevel on the plug end that I think is throwing off the thread alignment. The tool works great though!

quick print in PETG fit perfect both X1C and P1S

Prints easily and looks geat

prints great

prints great

works great I printed on my X1C and P1S and everything was interchangeable

printed great

printed and looks great

printed great with tricolor silk

prints great. it is a little thick for typical earing hooks. I just added some chain links to make it work.

prints well and works good, just a little bit tough to move the slider.

printed well and went together fine. it is a bit tight starting but works fine.

prints easily and looks great i used tricolor red blue green for the hand.

prints easily and looks great

prints very well, I added names to the hat band

prints great although if I use the flat trays, I can't use the cover for the ams no big deal but thought I'd mention it