Search models, users, collections, and posts
Bio
The prints of darkness
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
First ever contest entry! The Windicator V2 (there's a larger V1) is an easy to print weathervane / anemometer optimised for A1 mini #Windspinner #Contests
Everything is push fit, you'll just need two 608zz bearings and you'll be spinning beautifully even in a light breeze
GIF
Share
1
0
0
First ever contest entry! The Windicator V1 (there's a smaller V2) is an easy to print weathervane / anemometer optimised for A1 mini #Windspinner #Contests
Everything is push fit, you'll just need two 608zz bearings and you'll be spinning beautifully even in a light breeze...even if there wasn't a lick of wind when I made the gif >:(
GIF
Share
3
2
0
Share
0
0
0
Looks great, needed to scale up. It's about as uncomfortable as you'd expect a crown of antlers to be. Am going to try and hairdry to make it fit more comfortably.
Share
0
0
0
Worked great. Thanks
Share
0
0
0
printed great. wobbles like it keeps changing its mind
Share
0
0
0
Share
0
0
0
Share
0
0
0
A dab of superglue stops them moving on impact and damaging the wing
Share
0
0
0
Nearly melted my father in law's brain. 5 stars for that alone
Share
0
0
0
long key ftw. miles better than the short one
Share
0
0
0
tried a load of fancy locking ones but with only pla to play with, I prefer this one
Share
0
0
0
Share
0
0
0
precisely what I needed for my pond. what was a distracting splosh is now a melodious tinkle. thank you.
Share
0
0
0
works great. thanks
Share
0
0
0
Love this greedy little guy
Share
0
0
0
Printed fine on A1 mini and I really like it. Looks VERY fragile though so more ornamnet than toy. Tried to scale up to 130% and couldn't get the long outlines of the 1st layer to stick. I'm a newb so i'm sure that was my own incompetance.
Share
0
0
0
Share
0
0
0