Great print. I would love to have a 1-1/2 version.

It works well and combined with the T-nuts is a great practical print.

These tools are great and work as advertised. I printed them in Matte PLA with Green and Charcoal. Looks Awesome. The bench dogs were printed in PETG for more durability.

Great tool and an easy print.

Printed to match my office and workshop.

I printed a couple of these in PLA and later in PETG to save my spools. Thank you.

Printed them to match my Systainer USA/Tanos Antracite Systainers.

I printed them to match the anthracite Systainer USA/Tanos Systainers. Very nice print.

These are a great print for gluing up corner joints.

I updated the colors and changed it to .16 high quality.

The print was fine, but I think the tape measure size is wrong. I believe this is for a 16' tape and will not work for a 25'

These work perfectly. I printed a second one for another set.

This worked nearly perfectly. You need to be careful when installing the feet.

printed perfectly and works like a charm

I printed one to see how they would work and followed up with 2 more. Great job.

This worked perfectly. In the picture, you can see the Skadis boards, and a printed Skadis board working in conjunction with the clips.

I am not sure if it was the profile, but there are some missing slats in the end which means I can’t just use pellets.

Printed perfectly per se. I am using a PEI plate, and I should have reversed one of the pieces so that the texture was on one side.

Print worked great and it is a nice tool. I used it to clean up after printing it. ;-)