Great design and easy to assemble. I see a lot saying to glue the wires into the holes but didn’t like that idea, makes changing the igniter pretty hard. Insteed I found that inside the bbq lighters there’s a small rubber hose that’s just the right size to use as a sleeve. Just cut two 12mm lengths, reem the two holes out a little (I used a small screwdriver) super glue them in and slide the wires through them. I also found if you blow into the alcohol chamber before you close it up it fires heaps better, it’s like there’s not enough oxygen in there to ignite.

Fits good on my old Donkey Kong game.

I’ve printed a few different spools but this design seems to be way better in its strength.

Works well

I enjoyed the print, the finished results are pretty good but some of the connection points to be glued do need a little cleaning up to make the surfaces smooth enough to make a good connection.

Exellent design & print.

Printed nice

Printed great face down on the plate.

Great print, works well.

Pretty cool, printed good.

Use this print everytime I get a new filament colour, it’s a good print.

Printed great

This little frog came out great

No problems at all printed great

Fit the spools good no problems at all.